Cheat Engine

PukiMan · How do I cheat? Reputation: 0 Joined: 28 Jan 2006 Posts: 9

I got no problems finding data that contains numbers and change them and/or create trainer out of the code.
My problem is that I just don't know how to find the health/fuel and any other data, that doesn't contain numbers.
How can I find it? What I need to search for?
Any help would be nice.

Haruhi Suzumiya. · Posted: Sat Jan 28, 2006 10:39 am Post subject: Re: Noob need help.

PukiMan · How do I cheat? Reputation: 0 Joined: 28 Jan 2006 Posts: 9

There's no tutorial for my question.

Dark Byte · Posted: Sat Jan 28, 2006 10:57 am Post subject:

step 3 and 4

PukiMan · How do I cheat? Reputation: 0 Joined: 28 Jan 2006 Posts: 9

jayw · Cheater Reputation: 0 Joined: 28 Jan 2006 Posts: 28

how do u do step 4???

PukiMan · How do I cheat? Reputation: 0 Joined: 28 Jan 2006 Posts: 9

jayw · Cheater Reputation: 0 Joined: 28 Jan 2006 Posts: 28

hey puki...thx soooooooooooooooooo much........... i get it now xD.. now i need a bypass for global ms.... any ideas?

jayw · Cheater Reputation: 0 Joined: 28 Jan 2006 Posts: 28

lol...i need help again...how do u do step 6? wat's an asssembler?

PukiMan · How do I cheat? Reputation: 0 Joined: 28 Jan 2006 Posts: 9

Search for 100
Click on "change value" in the tutorial window
Second search: Search for the new value and add the address
Left click on the address and click on "Find out what writes to this address".
Click on "Change value" in the tutorial again.
Double click on the result (Or press once on the result in the "The following opcodes changed the selected address" window and click on "More Information") to check more info about it. In this case, we don't have anything complicated data. You can just copy the address of the value from the "Change Value" part that you found before (Remember. Copy the address, not the value!). After you copied the address. Press on "New search" button and mark the "hex" box near the value search window and paste the address you copied. It will find you couple addresses, but as I'm myself a noob, I can only suggest you to pick the first one. After that, you just need to click on "Add address manually" and check the pointer box. There, you write the address (Not the value!) of that result you just had few seconds ago and click ok.
Now, just change the value of the new addition (Don't touch the old value) to "5000", freeze it and click on "Change pointer" button in the tutorial window. You're done.
Hope my explanation wasn't confusing and helpful Very Happy