Mr.SnowGoon! Advanced Cheater Reputation: 0
Joined: 20 Sep 2009 Posts: 84 Location: langley, bc
|
Posted: Sun Dec 12, 2010 12:20 am Post subject: [XBOX360]Turning The Xbox Ring From Green To Orange[TuT] |
|
|
What you need:
a way to open your 360 (guides everywhere) ~ Look on you tube for an easy way to open your xbox with out breaking it.
Soldering iron
Flux + solder
thin wire for bridge
now take the RF board off the 360 and remove the white plastic cover and look at the pic below
Its pretty easy even if your not experienced with soldering just bridge both negative terminals on the Player 1 led together by putting a small peice of wire by the red and green negative points and then put flux on to hold it there and allow the solder to stick then touch the points with the iron and apply a bit of solder, NOTE - if it doe'snt make all lights orange you will have to do player 2-3-4 LED's too but some rf boards only need the player 1 light bridging (i always do all of them just incase but like i said only player 1 LED is needed in some cases .
This gives you a deep orange light on the 360 without breaking the bank and its also pretty easy to reverse too
I have it done on a stock 360 and here is the result.
Sorry about the pic quality its a phone camera and although the lights look red i can assure you they are orange.
~Credits:
m3ga st3vi3
|
|